Datamax O'Neil Compact4 Mark II Provozní pokyny stáhnout pdf (Strana 23)

5. Disconnect the Printhead Cable from the rear of the Printhead.



Printhead



Printhead Cable

To Install:

1. Connect the Printhead Cable to the rear of the Printhead.

2. Position the Printhead into the Printhead Carrier. Be sure the two Screw Heads on the Printhead are located into the

Holes of the Printhead Carrier

3. While pressing down on the Printhead Carrier, install and tighten the Printhead Screw using a Phillips Screwdriver.



Printhead



Printhead Carrier



Printhead Screw



Phillips Screwdriver



Screw Heads / Holes

4. It is now recommended to clean the Printhead to remove any oil or dirt from handling. Perform the Printhead

Cleaning procedure, (see section 4.2).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Žádné komentáře

Datamax O'Neil Compact4 Mark II Provozní pokyny Strana 23