Datamax-oneil H-Class GPIO Option Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Tiskárny Datamax-oneil H-Class GPIO Option. Datamax-O'Neil H-Class GPIO Option User Manual [en] [ru] [de] [es] [fr] [it] Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 14
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
GPIO Option
92-2427-01 Rev.C
Zobrazit stránku 0
1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - GPIO Option

GPIO Option 92-2427-01 Rev.C

Strany 2

8 ► COM C (J4) Recognized by the printer as Serial Port C, COM C functions as an auxiliary RS-232 interface or dedicated device port for the RFID

Strany 3 - Additional Requirements

9 Step 2: Installing the Option Install the GPIO Card as described below: AC ReceptaclePower Switch Back PanelScrewsCard Cage A) Tu

Strany 4

10 D) Place the Cover Plate (Item 2) onto the Card Cage, as shown, then install and tighten the two Screws (Item 3) to secure the plate. Cover

Strany 5

11 Step 4: Configuring the Software Settings Configure the printer’s menu settings for the option’s operation. A) Using the Control Panel, e

Strany 6

12 GPIO A Signals GPIO A Signals GPIO B Signals GPIO B Signals  Input Monitor – Display incoming GPIO binary signal states using the ADVANCED MENU

Strany 8

1 Overview This document describes the installation and use of the General Purpose Input Output (GPIO) option for the H-Class printer. After veri

Strany 9

2 COM C RS-232 Cables Part # 32-2300-01 Part # 32-2301-01 COM D RS-232 Cable Host DB-9S Printer RJ45P 1RXDTXD+5 VDCGROUNDTXD

Strany 10 - ► COM D (J3)

3 Step 1: Configuring the Hardware Configure the card to meet your interfacing requirements by arranging hardware jumpers, as described in the f

Strany 11 - Card Cage

4 For direct inputs – Use the printer’s +5VDC and Ground to supply the devices interfacing to the GPI/O A inputs (as shown in the sample circuit,

Strany 12 - Step 3: Interfacing

5 WARNING Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices. GPI/O Port A Jumper Overvi

Strany 13 - Signal In

6 ► GPI/O B (J2) Six unassigned inputs are designed to interface to open-collector outputs. These inputs require no external pull-ups, while bloc

Strany 14 - GPIO SIGNAL INFO

7 WARNING Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices. GPI/O Port B Overview Pin

Komentáře k této Příručce

Žádné komentáře