Datamax-oneil I-Class Mark II SDIO_USB Host Option Installation Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Tiskárny Datamax-oneil I-Class Mark II SDIO_USB Host Option Installation. Datamax-O'Neil I-Class Mark II SDIO_USB Host Option Installation User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 6
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
SDIO/USB Host Option Installation
92-2593-01 Rev.A
Zobrazit stránku 0
1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - 92-2593-01 Rev.A

SDIO/USB Host Option Installation 92-2593-01 Rev.A

Strany 3 - Tools Required

1 Overview This document describes the installation and use of the SDIO/USB Host option for the I-Class Mark II printer. Follow the steps to begi

Strany 4 - Installing the Option

2 Installing the Option Install the SDIO/USB Host Card as described below: A) Turn off and disconnect the power cord from the printer. Remove th

Strany 5 - Standoffs

3 C) Remove the 5mm Screw and Cover Plate from the rear of the printer. Cover Plate5mm Screw D) Install the two 6mm Standoffs into

Strany 6

4 E) Install the SDIO/USB Host Card into the printer. First insert the “Port” end into the cut-out in the rear of the printer. Then pivot the SDI

Komentáře k této Příručce

Žádné komentáře