Datamax-oneil Labelpoint Programmer’s Manual Uživatelský manuál stáhnout pdf (Strana 47)

PROGRAMMER’S REFERENCE MANUAL

Printer settings

Page 43

Parameter (i) Explanation

<n>

Print speed (mm/s).

<n> Barcode speed (mm/s). Can be set to a value lower or equal to the normal

print speed in order to get a higher print quality for matrix codes and vertical

(ladder) barcodes.

<n> Blank feed speed (mm/s). Can be set to a value higher than the normal print

speed.

<n>

Print head type. Caution: Setting the wrong type of print head will give poor

print quality and can even damage the print head. Valid values for n are:

0 = Unknown head

5 = Kyocera type KST

6 = Rohm type KF – 17B

7 = Rohm type KF – 13B

8 = Kyocera type KPC

Number of dots per mm on the print head. The value should be 8 dots/mm for

203 dpi heads, or 12 dots/mm for 300 dpi heads.

4,5

<n> Motor steps per mm. This parameter defaults to 24 for Compact and Nova

models. Valid values for n are any positive numbers.

Note! Modify this parameter with caution. An incorrect value will give a

distorted printout and cause labels to stop at the wrong position.

4,5

<n> Print head width, in number of dots. This parameter should be:

832 for Compact, 203 dpi head

1280 for Compact, 300 dpi head

832 for Nova DT, 203 dpi head

864 for Nova TT, 203 dpi head

<n> Dot mode. This parameter determines print behaviour when two print fields

overlap. Valid values for n are {0, 1} and they are interpreted as follows:

0 = black on black prints white, XOR (default)

1 = black on black prints black, OR

Manufacturing date. The result is formatted in a four-digit number, two digits

each for year and week (yyww). If the new serial number format is applied,

however, the manufacturing year is displayed using a single digit (i.e. yww).

16 <n> Force DT. Only used by TT printer models to be able to use the printer in DT

mode, that is, without ribbon sensing. Valid values for n are {0, 1} and they

are interpreted as follows:

0 = normal mode (default)

1 = forced DT mode

Read-only parameter.

Protected parameter. Must be unlocked with the !V38153 command first.

The printer has to be restarted for the new value to take effect.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 94 95

Komentáře k této Příručce

Žádné komentáře

Datamax-oneil Labelpoint Programmer’s Manual Uživatelský manuál Strana 47

Komentáře k této Příručce

Související produkty a manuály pro Tiskárny Datamax-oneil Labelpoint Programmer’s Manual