Datamax-oneil M-Class Mark II DMXNet II Card Option Uživatelský manuál

DMXrfNet II and DMXNet II Card Option 92-2486-01 Rev.D

Printer’s Internal Web Pages 8 Printer’s Internal Web Pages 1. Open your web browser. Type in the IP Address of the printer. The Default IP is:

Printer’s Internal Web Pages 9 TCP/IP Configuration Page Static IP Settings IP Address Subnet Mask Default Gateway These are the static address t

Printer’s Internal Web Pages 10 Wifi Configuration Page WLAN Network Settings SSID Service Set Identifier that identifies the Module to connect t

Printer’s Internal Web Pages 11 Wifi Configuration Page (continued…) Advanced Settings Maximum Transmission Rate Specifies the Module’s maximum wi

Installing the Printer Driver 12 DMX Config Utility DMXConfig (located on the Accessories CD-ROM) is a Windows based configuration utility that al

Installing the Printer Driver 13 Enabling Adhoc Mode:  Note: The following example uses the DMXConfig software utility to configure the printer.

Installing the Printer Driver 14 Installing the Printer Driver The following screen shots are taken from Windows 2000, other versions will be sim

Installing the Printer Driver 15 9 Insert the Accessories CD-Rom and click ‘Browse’. 10 Browse to the “\DRIVERS\Seagull” folder on the CD-ROM, m

USB Host Ports 16 USB Host Ports The USB Host Ports accept external memory storage devices for fonts, graphics, label formats, and firmware upgrade

Additional Information 17 Wireless and Wired Ethernet Specifications The following list and table describes the key features and specifications of

Card Installation 1 Overview This document describes the installation and use of the DMXrfNetII and DMXNetII Card options for the M-Class Mark II

Card Installation 2 Preparing the Printer (continued) 4. Open the cover, loosen or remove the two Screws from the inside of the printer as show

Card Installation 3 Installing the Communication Card 1. Insert the two supplied Standoffs into the printer’s Main Board as shown. Standoffs

Overview 4 Introduction The M-Class MarkII series of printers are available with several Communication Card options. These cards can be equipped

Network Setup 5 Network Card Reset It is recommended that the printer’s communication settings be reset to factory defaults to avoid any conflicts

Network Setup 6 Network Card Setup - Wireless (Infrastructure Mode) After a successful setup is made via a wired connection, the Wireless conn

Network Setup 7 Network Card Setup - Wireless (Adhoc Mode) To configure the wireless card in Adhoc mode, you must configure your host computer