Datamax-oneil Workstation series User Guide Uživatelský manuál stáhnout pdf (Strana 24)

3 | Connections and Setup

Workstation Series User’s Guide 16

Note: Be sure there are no labels attached to the backing that is routed behind the peel

and present sub-assembly.

Figure: 3 - 5 Media Backing

4. Pull the label backing tight to ensure proper tension of the label backing.

5. Hold the backing tight and close the peel and present sensor assembly.

6. Close and latch the printer cover.

7. Feed the paper to find top-of-form.

Note: Peel and present mode is enabled through the configuration utility. If both peel

and present mode and prompt mode are enabled at the same time, only prompt mode

will be active.

Label Backing

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 44 45

Žádné komentáře

Datamax-oneil Workstation series User Guide Uživatelský manuál Strana 24