Datamax O'Neil H-4310X Návod k obsluze stáhnout pdf (Strana 115)

H-Class 105

5.9 Replacing the Printhead

If the printhead needs to be replaced, follow the procedure below:

• Only use a Datamax-O’Neil IntelliSEAQ™ printhead.

• Printheads are fragile; handle with extreme care and never use sharp

objects on the surface.

• If you have questions, contact a qualified technician or Datamax-O’Neil

Technical Support before proceeding.

A. Turn OFF the Power Switch then touch a bare metal printer surface (e.g., the frame)

to discharge any static electricity present on your body.

B. Unplug the printer and open the access cover. If ribbon is installed, remove it.

C. Lower the Printhead Assembly and loosen the Printhead Mounting Screw. (If using an

H-8308X model, loosen both mounting screws.)

D. Carefully raise the Printhead Assembly. Grasp the printhead then disconnect the two

cables and remove the printhead.

E. Position a new printhead under the Printhead Assembly and connect the previously

removed cables.

F. After ensuring that the printhead cables are not pinched, place the printhead onto

the locating pins under the Printhead Assembly and secure it by tightening the

Printhead Mounting Screw(s). [Do not over-tighten the screw(s)].

G. Using a Cotton Swab moistened (not soaked) with isopropyl alcohol, clean the

printhead then allow it to dry.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 179 180

Žádné komentáře

Datamax O'Neil H-4310X Návod k obsluze Strana 115