Datamax-oneil H-Class Powered Internal Rewind Option Uživatelský manuál stáhnout pdf

Powered Internal Rewind Option

92-2432-01 Rev.C

1 2 3 4 5 6 7 8 9 10

Powered Internal Rewind Option 92-2432-01 Rev.C

1 Overview This document describes the contents, installation, and use of the Powered Internal Rewind option for the H-Class printer. After verifyi

2 DoorCatch Tear PlateThumbscrewAccessCover B) Press down on the Catch, then pull forward to remove the Door. C)

3 Step 2: Installing the Option A) Align the Rewinder Assembly (Item ) to the Center Plate opening then, while carefully seating it into the Po

4 F) Slide a three-inch diameter Media Core onto the Core Adapter Collar. (Note that the width of the Media Core should be at least as wide as

5 B) Load Media as you normally would, but extend about 20 inches (50 cm) of it from the printer –then proceed according to your application:

6 C) Plug the power cord into the AC Receptacle and turn ‘On’ the Power Switch. (Depending upon its database configuration and other attached d

7 Removing Stock from the Internal Rewinder The Internal Rewinder allows you to wind an 8-inch (203 mm) outer diameter roll of media or liner. Pro

Žádné komentáře

Datamax-oneil H-Class Powered Internal Rewind Option Uživatelský manuál