Datamax-oneil M-Class Mark II RFID Ready Option Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Tiskárny Datamax-oneil M-Class Mark II RFID Ready Option. Datamax-O'Neil M-Class Mark II RFID Ready Option User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
RFID Ready Option
92-2499-01 Rev.C
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - RFID Ready Option

RFID Ready Option 92-2499-01 Rev.C

Strany 2

8 UHF Option: G) Secure the UHF Module (Item 10) to the Mounting Plate using the four Standoffs (Item 11) and four Screws (Item 8). StandoffsScrewsU

Strany 3 - Overview

9 Step 3: Returning Operation A) Dress the installed cables into the existing cable bundle. RECHECK ALL CONNECTIONS. Lower and latch the Printhead

Strany 4 - Contents

10 D) Enable the option by following the instructions below: EXITSYSTEMENTERPRINT CONTROLTESTMENUREADYSTOPERRORPRINTER OPTIONSUSER MENUSYSTEM SETT

Strany 6 - Printhead Latch

1 Overview This document describes the contents and installation of the M-Class Mark II RFID options. Only qualified service personnel should per

Strany 7 - UHF Opening

2 Contents The contents of the kit differ according to the type of RFID option:  HF Option*: 1 Antenna 2 Regulator CCA 3 Mounting Plate 4

Strany 8 - Regulator

3 Tools Required A Phillips screwdriver is needed, and a PC with an Internet connection may also be required. Step 1: Checking Firmware A) Ver

Strany 9

4 B) Remove the Cover Screws on the outside of the printer. Cover Screws C) Raise the Cover. Loosen the Cover Screws on the Centerplate then

Strany 10

5 Step 3: Installing the Option A) Peel the backing from the Double-Sided Tape (Item 7). Affix the Double-Sided Tape to the recessed area of the A

Strany 11 - AC Receptacle

6 D) Route the Antenna Cable through the Cableway in the Centerplate. CenterplateCablewayAntenna Cable E) Loosen the Guide Screw and the Heat S

Strany 12 - Control Panel

7 HF Option: G) Place the Washer (Item 11) and then the Long Spacer (Item 10) onto the Screw (Item 8). Place a Short Spacer (Item 9) over the Long S

Komentáře k této Příručce

Žádné komentáře