Datamax-oneil Performance series User Guide Uživatelský manuál stáhnout pdf (Strana 34)

3 | Connections and Setup

Performance Series User’s Guide 26

12.Rotate the latch lever counter-clockwise until the printhead mechanism is locked.

Figure: 3 - 11 Lock the Printhead Mechanism

Note: If the media has been installed properly and read by the autoloading sensor, it

should automatically feed under the printhead once the printhead carriage assembly has

been latched and locked. If the media does not automatically load, unlatch the printhead

assembly and manually feed the media under the printhead. Upon locking the printhead,

it would be beneficial to both feed the media by selecting the Feed button on the main

menu to properly set the next label and perform a Paper Calibration.

13.Set the Top-of-Form sensor

Note: Refer to the section called “Top-of-Form Sensor”. Setting the top-of-form sensor to

read specific media characteristics is done in the control panel.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 142 143

Žádné komentáře

Datamax-oneil Performance series User Guide Uživatelský manuál Strana 34