Datamax O'Neil H-8308P Návod k obsluze stáhnout pdf (Strana 88)

C. Allow the printhead to dry. Reinstall media (and ribbon, if needed). Plug in the

printer and turn ON the Power Switch. Run a few sample labels and examine them. If

streaking is still present, use Cleaning-Card Procedure below; otherwise, this

completes cleaning.

Cleaning-Card Procedure (for users of direct thermal media, or thermal transfer media

with wax/resin ribbon combinations; also for unsuccessful Cotton Swab cleaning attempts):

A. Raise the cover, then raise the Printhead Assembly and wait briefly for the

printhead to cool.

B. Remove media and ribbon then place a Cleaning Card under the printhead. (Part

number 70-2013-01 for 4-inch cards; and, 70-2014-01 for 6-inch cards)

C. Close and lock the Printhead Latch and disengage the Leveling Cam.

D. Close the cover then navigate to Menu > Tools > Maintenance > Cleaning. Then

select “Clean Now.”

E. After the Cleaning Card has been run through the printer, reinstall media (and

ribbon, if needed). Plug in and turn ON the printer. Run a few sample labels and

examine them. If streaking is still present, use the Cleaning Film Procedure, below;

otherwise, this completes cleaning.

Cleaning-Film Procedure (for users of thermal transfer media and resin ribbon, when

printing with a Heat Value of 22 or higher, or when other methods prove unsuccessful):

A. Raise the cover, then raise the Printhead Assembly and wait briefly for the

printhead to cool.

B. Remove media and ribbon then place a sheet of Cleaning Film under the printhead.

(Part number 70-2087-01 for 4-inch film; 70-2087-02 for 6-inch film; and, 70-2087-

03 for 8-inch film)

C. Close and lock the Printhead Latch and disengage the Leveling Cam.

D. Close the cover then navigate to Menu > Tools > Maintenance > Cleaning. Then

select “Clean Now.”

E. After the Cleaning Film has been run through the printer, turn OFF the Power Switch

and unplug the printer. Open the cover then raise the Printhead Assembly and wait

briefly for the printhead to cool. Using a cotton swab moistened (not soaked)

with isopropyl alcohol, clean the printhead then allow it to dry.

F. Reinstall media (and ribbon, if needed). Plug in and turn ON the printer. Run a few

sample labels and examine them. If streaking is still present the printhead may need

to be replaced; see Section 5.3.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 115 116

Žádné komentáře

Datamax O'Neil H-8308P Návod k obsluze Strana 88