Datamax-oneil M-Class Mark II Static brush Uživatelský manuál stáhnout pdf (Strana 1)

92-2457-01 Rev.B

Installation Instructions

1. Turn ‘Off’ and unplug the printer.

2. Open the cover. Using the illustrations below, locate the area where the Static Brush will be installed.

3. Using a Cotton Swab or cloth, moistened with isopropyl alcohol, gently clean the surface where the Static Brush will be installed.

WARNING

Isopropyl alcohol is a flammable solvent; always take the proper precautions when using this substance.

4. Peel the backing from the adhesive strip on the back of the Static Brush and affix the brush to the printer in the location shown in

the below illustrations.



Note: The Static brush should be installed so the bristles are as close to the ribbon without actually touching. It may be necessary

to install a roll of ribbon in order to properly align the brush to the ribbon.

M-Class Printers



Note: For M-Class printers, the Static Brush must be cut to length in order to fit properly.

Static

Brush

1 2

92-2457-01 Rev.B Installation Instructions 1. Turn ‘Off’ and unplug the printer. 2. Open the cover. Using the illustrations below, locate the a

I-Class Printers StaticBrush H-Class Printers StaticBrush

Žádné komentáře

Datamax-oneil M-Class Mark II Static brush Uživatelský manuál Strana 1