Datamax-oneil S-Class User Guide Uživatelský manuál stáhnout pdf (Strana 57)

S-Class 49

4. Following a successful download, the printer will perform a ‘cold

reset.’ The previous printer setup will not be affected unless

substantial firmware data structure changes have occurred. Print a

Database Configuration Label to verify your new firmware version.

 Following an unsuccessful download, the FAULT Light will

illuminate then the printer will perform a ‘warm reset’ The original

firmware will remain operational. If the printer fails to reset, toggle the

power ‘Off’ and ‘On.’

Try re-sending the file to the printer. If the failure continues,

check the following possible causes:

An invalid or corrupted file is being downloaded - Ensure the file

being downloaded is correct and applicable for your printer model.

Possible communications error - Check the cable connection

between the host and printer and ensure that a quality, shielded

cable is used.

Possible Flash memory problem - Call for service.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 91 92

Žádné komentáře

Datamax-oneil S-Class User Guide Uživatelský manuál Strana 57